StarDot Technologies net camera Bedienungsanleitung PDF herunterladen (Seite 28)

Page 28 NetCam

3.8 Network Properties

The Network Properties page contains all the IP configuration

information for setting up NetCam on a network. After making changes,

click the Apply button to save the settings in the camera.

Ethernet

If your network is Ethernet-based (LAN, cable modem, DSL), use the

NET port on the back of NetCam to access the camera. The rst step to

network access is assigning NetCam an IP address. There are two ways in

which this can be done: automatically (DHCP) or manually.

IP Assignment

DHCP

By default, NetCam comes up in DHCP mode, meaning that it probes

the network for a DHCP server. If there is a DHCP server on the network,

NetCam is automatically assigned an IP address, subnet mask, gateway, and

name servers. No manual conguration is needed. One negative of DHCP

mode is not knowing which IP address NetCam was given. Use the StarDot

Tools software to nd DHCP-assigned NetCams on your local network.

Manual

If you’d like to manually assign NetCam an IP address, set NetCam to

Manual IP Assignment and provide the following information:

• IP Address - The IP address you’d like to assign the camera.

Consult your network administrator to determine which IP address

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 41 42

Keine Kommentare

StarDot Technologies net camera Bedienungsanleitung Seite 28